3/16/2023 0 Comments Backuplist auto ejectThe Linux CD supports restoration from network attached storage such as a shared folder on another computer or network attached disk. This will have been attempted at boot time, but may need to be invoked manually, for example where a network lead was not connected at boot time. The "Set" button applies any configuration changes, and "Get address" attempts to acquires a new address via DHCP. In this case, consider a windows PE rescue disk. Note: if there are no adaptors listed, then the Linux rescue disk does have support for your network adaptor. Select a network adaptor from the list and view or change the IP address and network parameters if incorrect. However, if your are having difficult creating a map to a network share, you can use the network settings button to confirm that the network is detected and configured correctly. If your image resides on a network attached disk, your network interface will require configuration. If you wish to eject a CD, double click on the CD icon. Note that the drive letters presented in the left pane may be different from those that Windows uses. In the case that your images are multi-part images – typical for images stored on a FAT formatted device such as a USB hard disk or on CD/DVD recordable media, locate the last image in the set. If you have an incremental/ differential set, chose the last image in the set, unless you wish to restore to an earlier point in time. Highlight particular backup image that you want to restore, the contents of which will be revealed in the lower right pane. The backup list shows all backup images in the selected folder and the pane below shows the partitions included in the image. Possible locations are network attached disks, CDs or DVDs, internal hard disks or those attached via USB or eSata. Navigate to the folder that contains the image to be restored in the left hand pane. Image locationįirst a Macrium image file must be located. It operates as a wizard, guiding you through locating an image, selecting what to restore and where to restore it to. Note, RAID systems and disks attached via USB3 interfaces are not supported in this rescue environment. If you require more flexible imaging and restore options or your hardware is not supported then use the Windows PE rescue environment. It will only enable your to restore your imaged partitions to exactly the same size and position as they were at the time the image was created. The Linux CD is a compact and efficient rescue environment to restore all Windows operating systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |